# Point Brick Before the First Freeze: Planning Newark Repointing This Fall

> Brick pointing before winter in Newark: why fresh mortar must not freeze, what the November 10 median first freeze means, and what to do if the job must wait.

URL: https://truecoursemasonrynewark.com/blog/point-brick-before-the-first-freeze/

Brick pointing before winter in Newark comes down to one rule: the new mortar has to cure in mild weather and must not freeze while it is still wet. NOAA's 1991 to 2020 climate normals for Newark Liberty International Airport put the median first fall freeze around November 10, and this post was written on October 22, which leaves only a few weeks of reliable pointing weather this year.

[True Course Masonry Newark](https://truecoursemasonrynewark.com/) repoints brick across Newark and Essex County, with the work carried out by licensed and insured contractors, and takes jobs of every size, from a few square feet under a sill to a full elevation. The [brick pointing service](https://truecoursemasonrynewark.com/brick-pointing/) page explains how the work is done. This post is about timing it.

## Why fresh mortar must not freeze

Mortar is mostly sand and binder mixed with water, and it hardens through chemical reactions that need that water and need warmth. The Brick Industry Association's Technical Note 1 explains that cement only hydrates completely when materials are at 40°F or above, and treats anything below 40°F as cold weather calling for heated materials and protection. Below that, curing slows and can stop.

If the water in a fresh joint freezes, it expands and breaks the young mortar apart from the inside. The joint may look fine for a few weeks, then powder, crack away from the brick or lose its face by spring. Lime-rich mortars, which suit much of Newark's older brick, harden even more slowly and stay vulnerable for longer. NPS Preservation Brief 2 puts suitable wall temperatures for repointing at about 40 to 95°F, and it is the temperature of the brick that counts, not just the air at noon.

## Reading Newark's freeze calendar

The NOAA normals give Newark a median last spring freeze around April 2 and a median first fall freeze around November 10, about 222 days between them. They also count roughly 80 days a year when the low is 32°F or colder.

Median means the date is passed in half of years, and in the other half the first freeze comes earlier or later. Nights near 40°F also come well before the first 32°F frost, and those are already marginal for curing. For practical planning:

- **Late September to mid-October** is the comfortable end of the fall pointing season.
- **Late October into early November** works for smaller areas, sunny walls and jobs that can be covered at night, if the forecast cooperates.
- **After about November 10,** exterior pointing generally waits for spring unless it can be enclosed and heated, which adds cost.

The [cold weather masonry guide](https://truecoursemasonrynewark.com/guide/masonry-work-in-cold-weather/) sets out the Brick Industry Association's temperature steps and what enclosures involve.

## A fall checklist

1. **Look at the joints now.** Recessed, sandy or cracked mortar on weather-facing walls, chimney tops and parapets is the priority. The [when to repoint brick guide](https://truecoursemasonrynewark.com/guide/when-to-repoint-brick/) explains what to look for.
2. **Decide what can wait.** Joints that are worn but intact can usually wait for spring. Open joints feeding water into a wall, or loose brick, should not.
3. **Get the scope written before the weather turns.** A first look checks the wall type, joint depth, brick condition, earlier repairs, water sources and access, so a spring job can start as soon as nights warm up.
4. **Never leave joints open over winter.** Cutting out mortar in November and refilling in April lets rain and meltwater straight into the wall.
5. **Fix the water first.** Clogged gutters and downspouts that empty against brick do more winter damage than worn joints. Clearing them costs little.

> Stay off ladders and roofs to check chimneys and parapets. Photos from the ground or a window are enough for a first look.

## If your wall has to wait

A wall that cannot be pointed this fall still benefits from a little preparation. Keep water away from it, photograph the worst areas so the spring scope is ready, and resist offers of a sealer or coating to see it through the winter. On older brick a coating can trap moisture and salts behind the face, as the [should you seal brick guide](https://truecoursemasonrynewark.com/guide/should-you-seal-brick/) explains. Chimney tops with a cracked crown are the exception worth acting on quickly, since water through a crown damages the brick beneath all winter; see the [chimney crown cracks guide](https://truecoursemasonrynewark.com/guide/chimney-crown-cracks/).

For budgeting the spring job, the [brick pointing cost guide](https://truecoursemasonrynewark.com/guide/brick-pointing-cost/) explains national ranges and what moves a Newark price, and the [tuckpointing vs repointing guide](https://truecoursemasonrynewark.com/guide/tuckpointing-vs-repointing/) clears up the terms that show up on quotes.

## Frequently asked questions

### Is late October too late to schedule repointing in Newark?

Not always, but the window is short. A small area on a sunny wall can often still be pointed and protected if the forecast holds above about 40°F through the curing days. A large wall, a north face or a high elevation that needs scaffolding is harder to fit in before the cold. If the job cannot be finished and cured in mild weather, it is better booked now for early spring than rushed.

### What does a median first freeze date actually mean?

It is the date by which the first 32°F night of fall has arrived in half of the years in the record. NOAA's 1991 to 2020 normals put that around November 10 at Newark Liberty International Airport. In the other half of years, the first freeze comes later; in many years it comes earlier. Low-lying or sheltered spots can also freeze before the airport station does, so treat the date as a guide, not a deadline.

### What should be done for a wall whose pointing has to wait until spring?

Reduce the water reaching it. Clean gutters, make sure downspouts discharge away from the wall, and note where joints are worst so the spring scope is ready. Do not let anyone grind joints out now and leave them open, and do not coat the wall to get it through winter. If brick is loose overhead, keep people clear and have it made safe, which is a separate, smaller job.